Engines
Qantas A380s Back in the Air
Qantas resumed flying two of its six A380s on November 26, after replacing some of their Rolls-Royce Trent 900 engines.
The European Aviation Safety Agency issued a revised emergency airworthiness directive covering Rolls-Royce Trent 900 engines just days before Australian flag carrier Qantas was due to resume flights with its Rolls-powered A380s. (Copyright Airbus)
The European Aviation Safety Agency issued a revised emergency airworthiness directive covering Rolls-Royce Trent 900 engines just days before Australian flag carrier Qantas was due to resume flights with its Rolls-powered A380s. (Copyright Airbus)

Qantas resumed flying two of its six A380s on November 26, after replacing some of their Rolls-Royce Trent 900 engines. In total, Rolls must bear the cost of replacing some 40 Trent 900s from the 20-strong fleet of Rolls-powered, four-engine A380s.

Meanwhile, on November 23, the European Aviation Safety Agency (EASA) issued a new emergency Airworthiness Directive, replacing an earlier emergency AD issued on November 10–six days after the uncontained failure of a Trent 900 caused extensive damage to the wing of a Qantas A380, forcing an emergency landing in Singapore. According to the EASA, fresh analysis of engine inspection data prompted the move to amend the required inspection procedure. The new AD retains the first directive’s mandate to inspect the Trent 900’s air buffer cavity, but it now instructs operators to focus also on the oil service tubes within the high pressure/intermediate pressure structure of the engine. It still requires operators to carry out initial inspections within 10 flight cycles of November 10 and at repeated intervals of no more than 20 cycles. The new AD omits the earlier directive’s requirement for inspecting the engines’ low-pressure turbine stage-one blades and case drain.