Matt Thurber, editor-in-chief at AIN Media Group, has been flying since 1975 and writing about aviation since 1978 and now has the best job in the world, running editorial operations for Aviation International News, Business Jet Traveler, and FutureFlight.aero. In addition to working as an A&amp;P mechanic on everything from Piper Cubs to turboprops, Matt taught flying at his father’s flight school in Plymouth, Mass., in the early 1980s, flew for an aircraft owner/pilot, and for two summer seasons hunted swordfish near the George’s Banks off the East Coast from a Piper Super Cub. An ATP certificated fixed-wing pilot and CFII and commercial helicopter pilot, Matt is type-rated in the Citation 500 and Gulfstream V/550. Based in the Pacific Northwest, Matt and his team cover the entire aviation scene including business aircraft, helicopters, avionics, safety, manufacturing, charter, fractionals, technology, air transport, advanced air mobility, defense, and other subjects of interest to AIN, BJT, and FutureFlight readers.

Editor-in-Chief

Matt Thurber

In 2008, the market hype about single- and twin-engine very light jets was at a peak, with what seemed like dozens of projects under way, and talk of VLJs darkening the skies prompting concerns among aviation authorities about how all this new traffic could be accommodated. In the midst of this frenzy, a small Oregon company called Stratos Aircraft unveiled the model 714, a single-engine, $2 million, all-composite jet that promised far better performance than its in-development competitors.&nbsp;


Fast forward a few years, and while Stratos Aircraft made some headway and even exhibited at the annual NBAA conference, the company quietly refined the design in a wind tunnel and began putting an airplane together. Then,&nbsp;on November 30 last year, test pilot Dave Morss lifted off in the prototype 714 from Roberts Field in Redmond, Ore., the airport closest to the company’s off-airport Redmond headquarters and manufacturing facility.


Since then Morss has flown the 714 thirty times for 40 hours, up to 250 kias (300 ktas) and nearly 15,000 feet. Plans are for him to fly the prototype 714 to this year’s EAA AirVenture show in Oshkosh, Wis., although he will have to stay below 18,000 feet because the 714 isn't IFR approved. The prototype also isn’t pressurized, although it has been pressure tested and can be pressurized, but the equipment to do so isn’t installed. The prototype will be fitted with a fresh interior and be painted before flying to Oshkosh.


The moniker 714 has a specific meaning, and it is spelled out in Stratos’s logo, the design of which illustrates the following attributes: “7” for Mach 0.7 top speed, “1” for one engine and “4” for one pilot and three passengers. From the beginning, Michael Lemaire (president and CEO), Carsten Sundin (chief technology officer), Kevin Jordan (chief sales officer) and Gordon Robinson (chief aerodynamicist) targeted ambitious performance goals:&nbsp;a 41,000-foot maximum altitude, max cruise of more than 400 ktas (now it is 415 ktas) and NBAA IFR range (100 nm alternate) with four occupants of 1,500 nm (at 402 ktas cruise speed). All this performance doesn’t detract from airport capabilities; at maximum weight, sea-level takeoff distance to 50 feet on a standard day is just 1,970 feet, and landing requires 2,240 feet. Time to climb to FL370 is 17 minutes. Total fuel capacity is 410 gallons. A baggage compartment is fitted above the engine and is accessible from outside the cabin.


<h2>Manufacturing and Production</h2>


Construction of the prototype began after Stratos secured fresh funding in 2012 and moved into the new facilities. This is also where manufacturing of the production aircraft will take place; composites will be manufactured in a new building that is under construction. Stratos engineers have designed and manufactured many of the airplane’s components, among them the landing gear, rudder pedals and other parts. Stratos is also incorporating 3-D printing into its design and production process. A Stratasys 3-D printer was used to print fuel system components, which could be checked for fit into the airframe well before the fuel systems supplier was able to make the parts. Then when the real parts arrived from that supplier, Stratos technicians simply exchanged them with the 3-D printed parts installed in the airframe.&nbsp;


There is one fairly significant change in the design, but this doesn’t affect the 714’s performance, and that is a change to a different engine. The original design was to have been powered by a 3,030-pound-thrust Williams International FJ44-3AP, but according to Sundin, “We weren’t able to obtain that engine.” So Stratos switched to the 2,950-pound-thrust Pratt &amp; Whitney Canada JT15D. “We can meet all of our goals [with that engine],” he said.


The next Stratos 714 will incorporate lessons learned from the prototype and will be much lighter, because some systems tested in the prototype were deemed unnecessary. One example is accumulators used in the hydraulic system, according to Lemaire. The hydraulic system drives the landing-gear actuators, speed brakes and the engine’s thrust attenuator. Another component under evaluation is speed brakes, which are large paddles mounted on the fuselage sides, but they might be unnecessary.&nbsp;


Morss told AIN that one of the biggest challenges in the flight control design is the 714’s sidestick. The ergonomics have to be just right for good control harmony and feel, because a side-mounted stick doesn’t have as much throw as a floor-mounted stick or a yoke. This is a matter of adjusting stick gear ratios and movement of control surfaces and servo tabs. The prototype’s left sidestick was also lengthened by two inches to give more leverage, which helped improve the control feel and authority. “This is the first jet I’ve flown with a sidestick,” he said. Rudder pedals will be adjustable in the final design.


While he hadn’t flown the full stall series before AIN’s visit in April, Morss had done a high-speed stall during envelope expansion. The full stall series will be completed before the trip to Oshkosh. During one test flight on a cold day, he took off at mtow and used less than 2,000 feet of runway, at Redmond’s 3,080-foot elevation. “This airplane is screaming to go out of a 2,500-foot strip,” he said. “Landing the 714 is easy. The trailing-link landing gear is just a delight.”


There is very little pitch change with thrust changes, because the engine is mounted so close to the center of gravity. But the arm from the tail to the wing is also long, which improves stability, according to Sundin.


After completing flight-testing on the first prototype, Stratos will run ground tests on a load-test airframe then test fly the second prototype. The company isn’t revealing projections for a certification timeline, but the second prototype will conform to the type design. “It’s looking really good,” Sundin concluded.

News and developments about airplanes, helicopters and unmanned air vehicles used in all varieties of operations, including airlines, military, business, commercial, general aviation and private.

Stratos Is Serious About Single-engine 714 

The first flight of the Stratos 714 single-engine jet last year shows that the program is back on track.

2024 Corporate Aviation Leadership Summit

Curt Epstein

News and issues relating to business, corporate and private aviation, primarily regarding turbine-engine-powered airplanes and helicopters. Subjects include aircraft, engines, maintenance, operations, personnel, acquisitions, accidents, safety, security, and training.

Only the piston aircraft segment posted a decline

GAMA: Bizjets, T-props, and Rotorcraft Deliveries Up

Hanneke Weitering

Two captains held the prototype 33 feet above the water for 30 seconds

Regent Flies Electric Seaglider with Crew for First Time

News about bills, laws, regulations and other governmental decisions affecting aviation and aerospace. Topics include FAA re-authorizations, taxes on fuel and aviation activities, environmental legislation, ICAO decisions, governmental mediation of labor conflicts and World Trade Organization disputes and decisions.

News and information on safety procedures and concerns.

Icing approval would open year-round service to northern communities

Horizon Begins Icing Tests for Cavorite X7 eVTOL

Kerry Lynch

Deal to close this year

Bombardier To Grow Manufacturing Capacity with MHICA Buy

David Donald

Essential news and analysis on the defense aerospace business. Your trusted source for new and ongoing programs and requirements in military aircraft (manned and unmanned), engines, avionics, weapons and associated systems, including ground-based air defense.

The two NATO allies will purchase seven of the tanker/transport aircraft

Spain and Poland Agree to Buy A330MRTT Tanker Transports

News and developments about aircraft engines, including turbofan, turboprop, turboshaft and piston.

News and issues relating to the aerospace industry that are related to the science, engineering and business of flight in space involving civil, industrial and military applications, and similar topics related to flight in the atmosphere of the Earth that are not covered more directly by other AINonline subject channels. In other words, both astronautical and aeronautical subjects, except for those aeronautical topics that are specifically covered elsewhere on this website.

News and issues relating to international air transport and cargo carriers, national airlines and regional airlines, including aircraft, engines, personnel, acquisitions, accidents, safety, security and training.

GE Aerospace has tested the GE9X, Leap 1A, Leap 1B, and more with the 747.

GE Aerospace Flies Boeing 747 To Test New Engine Tech

Charles Alcock

News about commercial airlines, including regulations, aircraft orders, safety, acquisitions, and mergers.

News about environmental issues relating to aircraft operations, including noise issues, emissisions, and regulations. See Fuel for biofuel.

More In Aircraft

GAMA: Bizjets, T-props, and Rotorcraft Deliveries Up

Only the piston aircraft segment posted a decline

Regent Flies Electric Seaglider with Crew for First Time

Two captains held the prototype 33 feet above the water for 30 seconds

Horizon Begins Icing Tests for Cavorite X7 eVTOL

Icing approval would open year-round service to northern communities

Bombardier To Grow Manufacturing Capacity with MHICA Buy

Deal to close this year

Spain and Poland Agree to Buy A330MRTT Tanker Transports

The two NATO allies will purchase seven of the tanker/transport aircraft

GE Aerospace Flies Boeing 747 To Test New Engine Tech

GE Aerospace has tested the GE9X, Leap 1A, Leap 1B, and more with the 747.

Helsinki Evaluates Hybrid-electric Flight Connections

City officials and a local university are working with manufacturer Electra

Zuri Prepares to Fly Hybrid-electric Cargo Drone

Platform offers 100 kilogram payload and 300 nm range

AIN Products

SUBSCRIPTIONS

RESOURCES

ABOUT AIN